The industrial oven is mainly powered by a stainless steel heating tube to generate heat. The industrial oven uses a high-efficiency centrifugal fan to use air flow to bring the heat in the heating tube to the inside of the studio, and exchange heat with the baked items in the studio to achieve baking or The purpose of drying. Old-fashioned oven products use mechanical temperature regulators and do not have over-temperature protection devices. If the temperature controller fails, the over-temperature will cause the baked goods or equipment to catch fire, which will cause serious safety hazards. Therefore, general industrial ovens now use intelligent temperature controllers to implement temperature control, and at the same time use a temperature protection switch as an independent over-temperature protector to limit the over-temperature of the product, which obviously adds a lot of reliability in terms of safety. So how to set the over-temperature protection device?
1. Before turning on the equipment, first turn the knob of the temperature protection switch clockwise to the limit. Then turn it on according to the steps specified in the manual. Otherwise, it may alarm and cut off the power when starting up. At this time, you need to turn off the power, adjust the temperature protection switch and turn it on again.
2. If the temperature of the working room has not reached the temperature set by the instrument after the power is turned on, the electric bell rings and shuts down, then the adjustment value of the temperature protection switch is lower than the set temperature of the instrument. Also need to turn off the power, re-adjust the temperature protection switch and turn on again.
3. If the temperature of the working room exceeds the temperature set by the meter after starting up, the over-temperature bell has not sounded. At this time, you need to fine-tune the temperature protection switch according to the instructions. In this way, once the temperature controller is out of control, the temperature protection switch can be used to cut off the power supply, so as to achieve the purpose of protecting products and equipment and avoiding major accidents.
Shenzhen Yihexing industrial oven meets the safety design of the national standard, equipped with insulation protection, over-temperature protection, leakage protection, overload protection, ventilation and pressure relief, combustible gas detection and alarm (special needs of some industries), etc., to protect your safe production.
