Oxidation Free OvenIt is a new type of anaerobic electric heating vacuum drying oven equipment, which injects nitrogen gas through the nitrogen hole to extrude the air in the oven and reheats to form the requirements of high temperature drying in a vacuum non-oxidative environment. Let's take a look at his safety operation rules:
1. Before electrifying the non-oxidizing oven, check that the insulation of the power supply line should be good, and no leakage is allowed. There should be no contact between the heater resistance wires to prevent short circuit.
2. Pay attention to the safe use of electricity. Install a power supply knife with sufficient capacity according to the power consumption of the oven. Select enough power supply wires and have a good grounding wire.
3. Open the exhaust valve before power-on, use a non-explosion-proof electric oven, and strictly prohibit volatile objects from entering the oven.
4. When placing the test product, it should be noted that the arrangement should not be too dense. The test product should not be placed on the heat dissipation plate, so as not to affect the upward flow of hot air. It is forbidden to bake flammable, explosive, volatile and corrosive items. Do not exceed the operating temperature of the oven.
5. The non-oxidation oven should keep the oven clean, and check and remove the oxide skin next to the resistance wire in the oven.
6. After the work is completed, the power supply should be cut off in time, and the drying door should be closed to ensure safety.
YihexingOxidation Free OvenFeatures
1. Using forced ventilation, there is an air duct in the oven, the temperature uniformity is 1.5%, and the material is evenly dried;
2. Adopt imported digital intelligent temperature controller, constant temperature control mode, PID automatic calculation, temperature control accuracy ± 0.2 degrees Celsius, with sensor disconnection alarm function, over temperature suppression, overshoot function, accurate temperature control, low overshoot , with over-temperature alarm protection function to ensure the safe operation of the product.
3. Double flow meter nitrogen saving system, double delay nitrogen filling control, greatly save nitrogen consumption in anaerobic and hypoxic environments.
4. The box door is sealed tightly with high temperature resistant silicone rubber strips at the junction of the box body, which has good thermal insulation performance, anti-aging, environmental protection and no pollution. The box door handle adopts a pull-type zinc alloy mechanical handle, which has high mechanical strength and wear resistance. Flexible door opening.
5. Using LED digital time timer, timing 09999H\/M\/S. Set temperature → set holding time → time to end END prompt-automatic cut off heating-alarm completion indication.
